Dynomotion

Group: DynoMotion Message: 8698 From: cncperfect Date: 11/21/2013
Subject: mach3 modbus
hi Tom
recently i receive kflop/kanalog board .i deciding setup them on the 4-Axis milling machine with 16 toolchanger
i builded modbus board that have 40 I/O for mach3 and it work perfect .
now for first question :
is it possible use this board with mach3 and kflop ?
Group: DynoMotion Message: 8699 From: Tom Kerekes Date: 11/21/2013
Subject: Re: mach3 modbus
Yes that should be possible.  You could connect it to the PC and use Mach3 Modbus.  Or connect it to KFLOP/Kanalog with up to  38400 baud, no parity, 8 bit data, 1 stop bit.  See the examples in:

C:\KMotion431n\C Programs\RS232\ModBus

Regards
TK

Group: DynoMotion Message: 8702 From: Amir Hossien Date: 11/22/2013
Subject: Re: mach3 modbus
Tom
i think you can convert some of this C code to graphical icon and setting in KmotionCNC software .
similar mach3 , in fact for example in mach3 Modbus initialise in very user friendly because user only see graphical setting and check box .
i am a proffesional Mach user but about Kflop i deciding use KmotionCNC .
i think KmotionCNC is a little rough and icy.
what is your opinion ?


Regard





On Thursday, November 21, 2013 11:49 PM, Tom Kerekes <tk@...> wrote:
 
Yes that should be possible.  You could connect it to the PC and use Mach3 Modbus.  Or connect it to KFLOP/Kanalog with up to  38400 baud, no parity, 8 bit data, 1 stop bit.  See the examples in:

C:\KMotion431n\C Programs\RS232\ModBus

Regards
TK

Group: DynoMotion Message: 8705 From: Tom Kerekes Date: 11/22/2013
Subject: Re: mach3 modbus
Hi Amir,

Yes you will probably find Mach3 easier to use.

Regards
TK

Group: DynoMotion Message: 8706 From: Amir Date: 11/22/2013
Subject: Re: mach3 modbus
Do yo can change this Conditions ?


On Friday, November 22, 2013 9:28 PM, Tom Kerekes <tk@...> wrote:
 
Hi Amir,

Yes you will probably find Mach3 easier to use.

Regards
TK